DIY Solar Panel Cleaning Guide – Step by Step Instructions

Many people who have solar panels on their roofs don\’t know how to clean them. Solar panel cleaning is a simple but important task. You must do if you want your system to work at its best and last as long as possible. Solar panels are subject to dirt and dust from the environment, birds and other animals, pests (rats), insects (ants), all of which can cause problems with your system. This poat is about DIY Solar Panel Cleaning Guide – Step by Step Instructions.It helps maintain maximum energy output from the panels. It also extends their life span, which equals significant savings over time.

Step by Step Solar Panel Cleaning Guide:

Step- 1

Fill a bucket with water and put in about two cups of dish soap.

Step- 2

Mix the solution, so it creates bubbles.

Step- 3

Thoroughly wet the surface of each solar panel by spraying them liberally or pouring out the entire bucket overall panels, starting at one end and working your way to the other side, top to bottom. Remove any dirt that is loosened up during this process using a rag or paper towel. Rinse off any remaining residue from the previous step by quickly dipping your brush into your cleaning liquid mixture before wiping down the next section of panels as needed for thorough coverage.

Step- 4

Repeat until you have scrubbed every inch of solar panels on both sides (top & bottom). Do not forget to clean the inverter on the back panel.

Step- 5

Rinse off any remaining residue from the previous step by quickly dipping your brush into your cleaning liquid mixture before wiping down any section of panels that may still have dirt or dust left behind as needed for thorough coverage.

Step- 6

Spray down each solar panel with a garden hose to ensure all visible areas and free soap suds. This spray will also prevent attracting new dirt over time, building up in dirty spots while bringing hidden soil particles to the surface to clean/scrub them away quickly. 

Step- 7

Solar Panel Cleaning is now complete! If you want more information about Solar Panels.

Step- 8

Remove any dirt loosened up during this process using an old toothbrush before rinsing off any remaining residue from the previous step by quickly dipping your brush into your cleaning liquid mixture before wiping down the next section of panels as needed for thorough coverage. Rinse until we thoroughly clean

Step- 9

All visible areas and free of soap suds when scrubbing Solar Panels with a toothbrush.

Step- 10

Apply a thin layer of silicon sealant on any cracks or gaps in your panel\’s frame to prevent moisture from getting inside them and causing corrosion.

Step- 11

Please press on the silicon sealant with a rag for about 30 seconds, making sure not to leave any air bubbles under the sun\’s rays that can break them down and cause your Solar Panels to rust.

Step- 12

Please wait until your panel is completely dry before using it again or exposing it to rain or other moisture, which will ruin Solar Panel Cleaning efforts.

Step- 13

Let dry for 24 hours before turning back on your system. Solar Panel Cleaning is now complete!

Cleaning solar panels is not an easy job, and it\’s imperative to take the time to do it right. Follow these steps to ensure that your system continues running at its peak performance level for years to come! We hope this DIY Solar Panel Cleaning Guide has been helpful—we want you to get the most out of your investment by following our handy instructions on how best to clean them, so they are ready for a few more decades of use without any problems. If you have any questions about cleaning solar panels or would like help with other aspects of maintaining your renewable energy system, please reach out anytime!